How do we measure for corner glass railings?——SmartArt glass railing

27 Mar.,2025

By following these steps,Smartart glass railing can ensure accurate measurements for corner glass railings,resulting in a secure and aesthetically pleasing installation.If you encounter difficulties,consider consulting with professionals who can assist with on-site measurements and installation advice.

 

How do we measure for corner glass railings?——SmartArt glass railing

When measuring the length of profiles,data measurement is usually based on the outeredge of the platform.Firstly,the length of the outer edge of the straight section ismeasured,as shown in sections A,B,C,D,and E in the figure below.Then,the width ofthe platform is measured,as shown in section H in the figure below.lf there is an arcsection,the radius of the outer arc should be measured,as shown in section F in thefigure below.Additionally,the linear distance between the two ends of the outer arcshould be measured,as shown in section G in the figure below.

It is important to note that there are two types of railing turns with corners,one to the inside and one to the outside,and the two types of connections are not the same.Need to specify,inside,outside.

When installing,due to the glass channel placement is not in the right place,it will lead to the middle of the aluminum length size problems.The correct way is to know the detailed size and install it according to the size.The second way is to place all the aluminum grooves first,connect them without any problem,and then fix them with screws.

How do we measure for corner glass railings?——SmartArt glass railing

To measure for corner glass railings accurately,follow these steps to ensure a perfect fit:

1.Gather Necessary Tools

Before starting,make sure you have the following tools:

A tape measure that reads down to 1/8 inch.

A notepad or drawing paper to record measurements.

A pencil or pen for note-taking.

2.Create a Rough Sketch

Draw a simple layout of the area where the glass railing will be installed.This sketch should include all corners and changes in direction.It doesn’t need to be perfect;it just needs to give a visual representation of your project.

3.Measure Straight Sections

For straight sections of the railing:

Measure from the outside edge of one post to the outside edge of the next post along the intended path of the railing.

Record these measurements in linear feet.

How do we measure for corner glass railings?——SmartArt glass railing

4.Measure Corner Sections

When measuring for corners:

Measure from the outside point of the corner where two sections of railing will meet.

Ensure that you account for any angles;typically,corners are at 90 degrees,but if they are angled differently,measure accordingly.

If using a corner post,measure from the outside edge of one adjacent railing sectionto the outside edge of the other.

5.Height and Post Placement

Determine the desired height for the glass panels and note where the posts will be placed,as this affects how much glass is needed and how it will be supported.

6.Allow for Adjustments

Leave a small gap(approximately 15-20mm)between glass panels for adjustments during installation.This gap allows for minor discrepancies in measurements.

7.Document Everything

Clearly write down all measurements and take photos if necessary.This documentation will help when placing an order or discussing your project with professionals.

By following these steps,Smartart glass railing can ensure accurate measurements for corner glass railings,resulting in a secure and aesthetically pleasing installation.If you encounter difficulties,consider consulting with professionals who can assist with on-site measurements and installation advice.